Varizoom VZCINEMAPRO-K5 User Manual

Cinema Pro-K5 Operations Manual

Mechanical travel: unlimited unless hardwired. Camera Plate dimensions- From Center mounting hole- tilt arm: 5” (with standard nodal line plate inst

Tilt arm connectors, back Video in- BNC Bloop/sync (optional)- 6pin Fischer Camera control (optional)- 12pin LEMO (white) Camera Power- 2pin LEMO (red

2 N.C. 3 N.C. 4 Camera Pos. Loop to Power Connector *** WARNING: DO NOT POWER THE CINEMAPRO WITH ANYTHING OTHER THAN THE INCLUDED FACTORY POW

6 Remote Direction 7 Clock out 8 Sync out 9 N.C. 10 N.C. 4) * Optional - Peripheral Connector – EGG1B308CLL Pin Functi

Pin Function 1 Common 2 Enable 3 Run – push/pull 12 volts 4 Camera run relay Pin1 5 Run pulse – 5 VDC

16 24 VDC – Lens Connection Table Lens Control, 16 pin LEMO FGG2B316CLAD Fujinon Digital Fujinon Analog Fujinon Telecon Can

1 Center 18 to 36 volts input 2 Common 2) “CTRL” - Cinema Pro Control (green) – LEMO EGG1B307CLL Pin Function Wire Color (Cable) 1

2 +5 VDC 3 Pan encoder signal “A” 4 Pan encoder signal “B” 5 Tilt encoder signal “A” 6 Tilt encoder signal “B” 5) “BLOOP” - Sync & Bloop – F

BEFORE YOU START, READ THESE WARNINGS 1) NEVER PLUG POWER DEVICES OTHER THAN THOSE SUPPLIED BY VARIZOOM INTO THE SYSTEM. ONLY USE VARIZOOM POWER SOU

General Description The Cinema Pro is a mid-size, two axis motion control head. It has a wide variety of operating modes: manual operation from jo

1. Basic Setup Secure Cinema Pro head to crane, tripod, or solid mounting beam Plug the FACTORY POWER SUPPLY into AC mains Connect XLR cable between

* make sure that the MDR2 is not connected to any power source (including batteries) prior to connecting to the head. This can result in damages to

Joystick deadband After sync is established (the “sync” light on the jibstick should be illuminated), switch on motor power (See below for location)

Communication connector (Green)- Connect this to the communication cable, and connect the other end of the communication cable to the green connector

4. Options and Specs Additional Software- The Cinema Pro head can operate as a slave to Kuper Node motion control software, and is also is capable of

Dedicated video sliprings can be fitted on the Cinema Pro head to allow high quality SD video to pass through the head. There is a 2db signal loss th