1 VZ-SnapCrane-12 Professional Modular Camera Crane Instruction Manuall For a video tutorial “SnapCrane Build, Design and Assembly”, go to
2 Parts List Crane Arm Sections 1) Tail Section (short) w/ sliding micro-adjust counterweight 2) Pivot Section w/ half-moon shaped brake plate 3) 1
3 SNAPCRANE MODE GUIDE Compact Mode (front pivot hole, use black cable 4) Arm Sections used: Front and Pivot sections only Camera capacity: up to 50
4 TRIPOD & DOLLY SETUP Before assembling your crane, make sure the dolly is on a completely flat, level surface. Insert the tripod feet into the
5 Extension Section 1 If using the Crane in the 2 shortest modes, you can skip this section and go to “Front Section.” Next you will need to attac
6 TAIL SECTION Attach the Tail section to the rear of the pivot section. Loosen the dovetail lock screw just enough to allow the two sections to e
7 Next, place the cable over the cable guide and secure the other end to the latch point at the front of extension section 1. Note: You
8 Counterweighting and Mounting Remote Head & Camera Slide the weight bar through the hole at the back end of the tail section. There is a not
Comments to this Manuals